Valves and Fittings Service Station : ARK Petroleum Equipment, Inc.

Benford Fueling Systems, Gas Station equipment, service and sales

Home | Catalog Index | Classified Ads | Contact Us | Site Map

Catalog Index

Fuel Control, Payment

Hose and Cable Reels

Lubrication Equipment

Meters

Printer Paper, Ink Ribbons

Valves and Fittings - Service Station

OPW 10BF-5725 Female Top Emergency Shut-Off Valve
$106.74
OPW 10 Series Emergency Shut-off Valves are installed on fuel supply lines beneath dispensers at grade level to minimize hazards associated with collision or fire at the dispenser. If the dispenser is pulled over or dislodged by collision, the top of the valve breaks off at the integral shear groove, activating poppets and shutting off the flow of fuel.

OPW 10BM-5825 Male Top Emergency Shut-Off Valve
$98.80
10BM-5825
Same as above with 1 1/2" Male Top.

OPW 10BU-5925 Union Top Emergency Shut-Off Valve
$112.42
10BU-5925
Same as above with 1 1/2" Unoin Top

OPW 10RFT-5750 Female Replacement Valve Top
$49.97
10RFT-5750

OPW 10RMT-5850 Male Replacement Valve Top
$49.97
10RMT-5850

OPW 10RUT-5950 Union Replacement Valve Top
$47.69
10RUT-5950

OPW PA15 Offset Adaptor
$43.95
PA15
The OPW PA15 Offset Adaptor is designed for adjusting misalignment of pipe in dispenser sumps and suction stubs. The PA15 has a low profile feature, and is designed for maximum flow. Available in 1", 1 1/2" and 2" offsets

OPW 60V Series Vapor Line Shear Valve
$55.60
60V-1000
"Line Saver" Shear section brakes on impact to minimize damage to underground vapor piping.

OPW 60VS Series Vapor Line Shear Valve
$107.72
60VS-1000
"Line Saver" Shear section breaks on impact to minimize damage to underground vapor piping.

OPW 70 Vertical Check Valves (with shear groove)
$69.00
70-0070
OPW Vertical Check Valves are installed on suction system fuel lines directly below the inlet to the pump in the dispenser island to maintain prime. The 70 Series Valves feature a built-in shear groove, which helps minimize piping damage if the dispenser is pulled over or dislodged by collision.

OPW 70S Vertical Check Valves (with shear groove)
$94.73
70S-0075
OPW Vertical Check Valves are installed on suction system fuel lines directly below the inlet to the pump in the dispenser island to maintain prime. The 70S Series Valves feature a built-in shear groove, which helps minimize piping damage if the dispenser is pulled over or dislodged by collision.

OPW 15 Union Check Valve
$32.75
15S-1233
OPW Union Check Valves provide a method for temporarily stopping the loss of prime caused by a damaged foot valve, angle check valve, or vertical check valve. They are easily inserted into an existing union and can be used until the damaged valve is repaired or replaced.

OPW 86 Double Poppet 1 1/2" Foot Valve
$188.29
86-0022

OPW 14 1 1/2" Angle Check Valve
$105.26
14-0033
The Model 14 features a metal-to-metal seat. OPW Angle Check Valves are recommended for use on suction lines where the pressure does not exceed 34 ft. of head (approximately 15 psi / 1 bar).

Kingston FK303-500 1/2" Non-Locking Lift Air Control Valve
$86.74
FK303-500
The Kingston Hoist Control valves are designed to operate various lifting devices utilizing compressed air (or oil) as a power source. The valve body is of heavy cast brass construction with internal components of precision machined brass bar stock, stainless steel springs, stainless steel inlet screen and Buna-N-Seals to provide long life with minimum maintenance. These valves are widely used on automobile, truck hoists and spring loaded single acting cylinders. Each valve is individually tested after assembly. Maximum operating pressure, 200 PSIG. If the application calls for the pressure source (air or oil) to be disconnected while the lifting device is in use, a check valve must be installed on the valve inlet to prevent reverse flow. Should reverse flow occur, serious injury may result when support for the load is reduced. Fig. 303 valve is more compact, but air volume has not been sacrificed. Positive air control is achieved by the cam action of the "dead man" style lever.